Builder's Special
A resourceful sound mixer sources some local design talent, rolls up his sleeves, and builds small, green, and affordable in Bozeman, Montana.
Brian Whitlock had been living in Jackson Hole, Wyoming, for 15 years when he began to experience an acute case of SSTF (Swanky Ski Town Fatigue). This affable, artistically inclined sound mixer for documentary films and TV longed to put down roots in a low-key community populated by fellow creative souls. And he needed to do it on a budget, which aced him out of Jackson Hole.
Whitlock ultimately settled one state north, in the laidback college town of Bozeman, Montana, where he lucked upon a lush, near-to-downtown plot of infill land bordered by century-old hedgerows and three graceful ash trees. He dreamed of a Michelle Kaufman–designed prefab home, but the price—$225 per square foot—was too steep. It turned out, however, that a custom design was less expensive than his prefab fantasy. Intrinsik Architecture, a progressive, collaborative Bozeman firm accepted Whitlock’s challenge: Create an efficient, mountain-ready modern home for $150 per square foot.
Just Glaze
Double-glazed windows are typically composed of two layers of glass with a layer of air in between. You might spend more on them upfront ($200–$1,500 each), but the extra insulation can save loads on your heating bill and more than recoup your investment over time. weathershield.comWhitlock was a hands-on client in the most literal sense—his flexible work schedule permitted him months at a stretch to labor full-time on the house with his contractor, Josh Blomquist of CWJ & Associates. Though hardly a journeyman homebuilder, Whitlock wasn’t afraid of getting his hands dirty, especially if it meant saving some cash. Of all his toil, though—cabinetry, hardscaping, building furniture and concrete forms— he is perhaps the most proud of his DIY electrical work. The cost of hiring an electrician can account for 10 to 20 percent of a building, so by wiring the house himself he saved around $30,000. “People have a visceral fear of electricity, which is healthy in some ways,” he says. “But I think it gets a bad rap.”
Those in the “scared of electricity” majority take heart—Whitlock learned a trick worth passing on to your electrician. “Run conduit for locations where you might need future electrical,” he advises. “I ran conduit between panels and subpanels, to exterior locations for outdoor lights, and between my office and the mechanical room.” You never know where you’ll need to plug in in the future, but Whitlock is set if his electrical needs change.
Color Me Rad
To give the exterior of your home a chic, contemporary veneer without splurging on expensive cladding, use a bold accent color.One of the most ingenious money-saving tricks Whitlock and the Intrinsik team employed on the interior is the perfect marriage of custom and off-the-shelf. “I used the Pax closet system from Ikea in a birch finish for both wardrobes and the storage wall in the downstairs bathroom,” he says. Using the company’s online planners and collaborating with Intrinsik principal Dan Harding, he tweaked interior walls to fit the Ikea units to achieve a built-in, high-end look. “It makes cabinets and closets look much more custom than they are,” he explains.
Pro and Con(crete)
For Whitlock, using concrete for the first floor was an inexpensive alternative to stone, wood, or tile. “I just poured the foundation and it gave me my finished floor,” Whitlock says. “Way simpler!”Don't miss a word of Dwell! Download our FREE app from iTunes, friend us on Facebook, or follow us on Twitter!
Advertising
Advertising
Advertising
Related Products
-
Sun-Mar Self-Contained Compact Composting Toilet
Fiberglass bowl and body /Electric composting…
-
Purist Wading Pool Lavatory Sink
The shallow design and angular edges make this…
-
Whole Bathroom Boost Box
by Boost HomeThe Whole Bathroom Kit from Boost Home can…
Latest
-
05.22
ICFF 2012 : Design Milk Presents
"Reinvention; Writing History in Aluminum" showcases a…
-
05.22
ICFF 2012: Brass Tactics
Everywhere we looked on the show floor of ICFF, we saw our own…
-
05.20
ICFF 2012: New from Black + Blum
Two products we really loved from the ICFF show floor came…
Follow
Dwell
Reloading tweets…














As always would love to see the floor lay-out. I suspect the reason is security or privacy? I love the house however...everyone involved should be proud. A great place to live I'm sure! Oh! What's the exterior cladding? Is it metal...asphalt...cement...???
This is what I like to see. Floor plans would be great. I want to know how long did it take to complete.
There are floor plans on our website: http://intrinsikarchitecture.com/?cat=16 To answer the other questions, bonderized steel shingles are used on the exterior and the project took approximately 8 months to complete. Thanks for the great comments!
Way to go Intrinsik!!
I recently read the story in the magazine, and nice place! I do have a question though. What kind of skull is that hanging on the wall above the bottles on page 73? Thanks!
the exterior finishes are so bold, but seem to be economical. i'm curious about the brand of the "shingle cladding" from a distance so monolithic and modern...but some of the closer shots reveals the traditional texture.
How much do I LOVE Intrinsik Architecture in Bozeman, MT? SOOOOOOOOO much---good work by good architects hired by good client people------
Nice work, Intrinsik!
Love this house! And love my CWJ/Intrinsik house too! Great folks to work with in every way!
Well josh golly - looks like it's time for another infamous pork sushi party in this stylish abode to celebrate. Congrats to all involved.
It was a pleasure from start to finish working with Dan Harding and Henry Foch at Intrinsik, carpenter and metal fabricator extraordinaire Luke Winne, and of course Brian (aka Montana Bob?) as a quick to learn and always willing crew member. I feel fortunate to have been involved.
My wife and i were visiting San Diego and had lunch at a local Restourant that has the same exterior wood finish this house has that we loved. We're almost done without house addition/remodeling and would love to add this ripe of wood finish on the stucco of the new 450 sq.ft. addition to mix the old and the new together. But do not know what kind of wood panels are these, can I know the name of the wood please! Thank you
I had the opportunity to work with CWJ in the early years. Josh and his associates are absolutely top notch. I am grateful to have had the opportunity to laugh and learn from the best. Keep up the great work! The house looks awesome.
great house...I read the article last night while watching the super bowl. My father is a retired architect and he loves it also. Really good work.
Josh, This is great to see! Can I get a tour of other CWJ/ Intrinsik collaborations. As Mr. Mackey stated above, "Absolutely Top Notch" work.
Who is the manufacturer of both the solid green and the aluminum+glass garage doors used on the garage?
Love this house! Can you tell me what product is used for the driveway? I am looking for a cool permeable surface and really like this one. Thanks.
The garage doors aren't anything special or unusual. I got them through Kaufman overhead doors in Bozeman. The solid door was delivered un-assembled and I painted the panels myself, then the installer assembled them. The glass door was about twice the price of the solid door, but still cheaper than putting windows in the garage.
The driveway pavers are impossible to find! I salvaged these from my neighbor Shannon, two blocks away. They were stacked in his yard behind the apartment I was renting while I built the house. I found another dozen of them in a local landscaper's backlot stock. In fact, I owe that guy 132 bucks!
The cladding on the house is not any particular brand. Dan Harding (Intrinsik Architecture) came up with the idea and Josh (CWJ Construction) figured out how to have them made. He went to Bridger Steel, a local sheet metal distributor, and had them punch out 1' squares from bulk rolls. They're attached with a roof nail gun. It was 34-degrees and raining sideways when Johno and Matt put most of them up. When I first priced it out, it was pretty cost effective, given that it never needed to be painted. Then steel costs skyrocketed! It hurt.
I love the two green chairs on the patio! What, where, how? Just furnishing our own similar back patio and I want them! Beautiful house too, great work!
Congrats Brian!! Well done! Would love to stop by for one of your many parties sometime and catch up! J.kelly. Ranchboy@ jhmail.com
RSS Feed
Add a Comment